Driver Ethernet
Bugs:
- PSDRVETH-180: Linking with eCosPro failes with missing symbol
New Features:
- PSDRVETH-66: Define ioctl service to retrieve timestamp wrap around values
Changes:
- PSDRVETH-178: Use a single SDK component for all targets
- PSDRVETH-175: Adjust PHY parameters for netX90
- PSDRVETH-171: API change: Implement newest definition of IOCTL DRV_ETH_IOCTL_GET_PORT_DELAY
- PSDRVETH-149: DrvEth_OS_common.c is not compiled into netX90 libdrv_eth.a, component thus not usable in netX90 projects.
- PSDRVETH-147: [netX90] PHY gets no link when auto-neg is configured at startup
- PSDRVETH-145: Separate DrvPhy from DrvEth project and use this separate project in DrvEth afterwards
- PSDRVETH-120: Remove control command DRV_ETH_IOCTL_SET_INGRESS_EGRESS_LATENCY
- PSDRVETH-65: Redesign Timestamping related API
Changes:
Changes:
Changes:
- PSDRVETH-149: DrvEth_OS_common.c is not compiled into netX90 libdrv_eth.a, component thus not usable in netX90 projects.
Changes:
- PSDRVETH-147: [netX90] PHY gets no link when auto-neg is configured at startup
- PSDRVETH-146: Provide DrvEth_Startup_Init() also for rcX-based systems
Changes:
Changes:
Changes:
- PSDRVETH-147: [netX90] PHY gets no link when auto-neg is configured at startup
New Features:
- PSDRVETH-143: Add possibility to check if connected phy is fully supported
Changes:
Bugs:
Bugs:
- PSDRVETH-140: Bad side effects of powering down the netX90 INTPHY
Bugs:
Changes:
New Features:
New Features:
- PSDRVETH-131: Define IOCTL to delete all registered Multicast MAC Addresses
- PSDRVETH-129: Add function to activate ethernet phy after timeout after poweron
Changes:
Bugs:
- PSDRVETH-127: Reintroduce hardened "autoneg restart state machine"
- PSDRVETH-125: Restaring autoneg after link up causes infinite loop linkchange-restartautoneg
- PSDRVETH-93: No parameter check for DRV_ETH_IOCTL_START command
Bugs:
- PSDRVETH-127: Reintroduce hardened "autoneg restart state machine"
Bugs:
- PSDRVETH-125: Restaring autoneg after link up causes infinite loop linkchange-restartautoneg
Changes:
- PSDRVETH-124: Change Version number to V1.7.0.0 for creating a new release version
Bugs:
- PSDRVETH-122: Unexpected context when calling Linkstatus callbacks
- PSDRVETH-112: Debug assertions cause stack overflow
- PSDRVETH-111: Ordering of link change events and related problem with debouncing of MAU type changes
- PSDRVETH-110: netX90 PHY: Add a delay between programming of a fixed duplex mode and the PHY fixup routines
- PSDRVETH-97: netX90 phy cannot be configured for fixed speed/duplex settings
- PSDRVETH-96: netX90 phy cannot be configured to Auto-MDIX
New Features:
Changes:
Bugs:
- PSDRVETH-104: Distributed wscript uses "eCos" in target names rather than "ecos"
New Features:
Changes:
Bugs:
- PSDRVETH-122: Unexpected context when calling Linkstatus callbacks
New Features:
- PSDRVETH-82: Implement support for eCos data provider
- PSDRVETH-71: Add preliminary support for eCos operating system
Changes:
New Features:
Changes:
Bugs:
- PSDRVETH-73: Advertised autonegotiation modes not properly reported
- PSDRVETH-67: Missing definement for all ethertypes